Setting Options Description
Offset Head Alignment –10 to +10 Use this setting when you change the
platen height but do not want to
perform Head Alignment. One stop
down on the platen (3 to 4 for example)
is equivalent to a +3 setting. Also used
for fine-tuning alignments when a
spacer pad is used to raise the flat
surface of the garment to be imaged
on.
Feed Adjustment –1.00% to +1.00% Select to adjust the platen feed each
time the print head moves; select a
higher number if dark lines appear or a
smaller number if faint lines appear
Power On Cleaning White Ink Available only in White Ink mode
On (default) Select to set up automatic white ink
cleaning
Before Printing
On: select to clean automatically
Off
whenever the printer power is turned
on and the printer initializes
Before Printing: select to clean
automatically whenever the printer is
turned on, but only before printing for
the first time since the printer turned on
Parent topic: Using the Control Panel Menus
Related tasks
Aligning the Print Head
Cleaning the Print Head
Adjusting the Height of the Platen
Print Logs Menu Settings
Settings on the Print Logs menu let you print information about print jobs.
134
To Next Page
Loading...
Need help?
General