Cleaning Around the Print Head
Cleaning the Platen Path
Lines Are Misaligned
If the vertical ruled lines are misaligned, try these solutions:
• Align the print head.
• Use Offset Head Alignment to fine tune registration.
• You may see lines in Auto (bi-directional) print output depending on the unevenness of the shirt's
surface. If this occurs, perform Head Alignment. If lines are still misaligned even after aligning the print
head, set Head Move Direction to Uni-Directional in the Garment Creator software or the printer's
control panel. If lines are still visible, adjust the print quality settings in the Garment Creator software.
Parent topic: Solving Print Quality Problems
Related tasks
Aligning the Print Head
Grainy or Unclear Printout
If your printouts are grainy or unclear, try these solutions:
• Clean the suction cap.
• Run a nozzle check to see if any of the print head nozzles are clogged. Then clean the print head, if
necessary.
• Align the print head.
• Clean the surface of the T-shirt. Remove any lint with sticky tape or a lint roller, and press the fibers
flat with a hard roller when you load a T-shirt on the platen.
• You may need to increase the image resolution or print at a smaller size (optimal image resolution is
360 dpi); see your software documentation for instructions.
• For colored prints on white T-shirts, try using Ink Blot Reduction mode in the Garment Creator
software. (This mode is not applicable when White ink is used.)
Parent topic: Solving Print Quality Problems
Related tasks
Cleaning the Suction Cap
Performing a Nozzle Check
Aligning the Print Head
151
To Next Page
Loading...
Need help?
General