1.
2.
3.
4.
5.
6.
This chapter shows you how to set the tracer-centerer-blocker and the edger according to your use. You can:
configure the tracer-centerer-blocker and the edger (p.107) (hour, date, language, logins, saver of screen),
customize the tracer-centerer-blocker (p.110),
adjust the precision of the edger (p.114),
restoring the factory settings (p.117)
1. Configure the tracer-centerer-blocker and the edger
This section describes the procedures to:
set the time, date and language (p.107)
access the connections and the network (p.109)
configure a screensaver (p.108).
a. Time, date and language
To reach this menu from your working screen, select > > > .
The following screen is displayed:
Time
Use the and arrows to set the time.
Date
Use the and arrows to set the date.
Type of date display
Select the type of display out of the available formats.
Language
Select the flag corresponding to your language.
Languages continued
Press to display the following languages.
Confirm
Press to save the new configuration.
To Next Page
Loading...
Need help?
General
