1.
2.
3.
4.
5.
6.
7.
8.
6. Statistics and technical history of the edger
This menu enables you to visualize the number of cycles carried out by the edger. It also gives you access to the technical history.
Edger cycles (p.133)
Technical history and errors (p.134)
a. Edger cycles
From the work screen, select > > > to visualize the number of cycles performed by the edger.
The following screen is displayed:
Partial counter
The replacement of a worn tool with a new one resets the partial counter(s) to zero.
Total counter
Edging operations
Number of edging, drilling and finishing operations performed depending on the lens material:
Roughing
Bevels
Flat-edge finish
Grooves
Drill-holes/slots
Notches
Polishing
Chamfers
Drilling
Number of drilling operations performed for each lens material, according to the drill bit used.
Touch screen calibrations
Number of lenses cut
Dressing cycles
Glass roughing wheel / Finishing wheel / Polishing wheel
Next page / Previous page
To Next Page
Loading...
Need help?
General
