Description of the symbols (p.152)
Modifications (p.152)
Compliance (p.152)
Copyright (p.152)
Materials and products (p.152)
Security (p.153)
Electromagnetic waves (p.153)
Symbols
SYMBOLS PRESENT ON THE DIGITAL SYSTEM
O Off (power)
I On (power)
D.C. current
asynchronous motor speed
Caution: risk of electric shock
Caution: danger, refer to the user manual
Manufacturer
Year of manufacture
SYMBOLS PRESENT IN THE DOCUMENT
Danger: risk of injury
Caution: risk of damage for the machine or the lens
Note: additional information
Tip: practical advice for use
Glossary: indicates a word defined in the glossary
See also: indicates the page number to consult for further information
Modifications
The information contained in this document is non-contractual and provided as a guide. It is subject to change without prior notice. Errors or omissions may occur in this
type of document, although the greatest care has been taken to ensure the accuracy of the information provided. Essilor cannot be held responsible for any malfunction or
loss of data resulting from such errors or omissions.
Declaration of conformity
Complies with marking:
Complies with ISO 16284 standards, IEC 61010-1 and IEC 61326-1 and with directives 200/42/CE, 2014/30/UE, 2014/35/UE.
This equipment complies with the limits imposed by Part 15 of the FCC rule. Its use meets the following conditions: (1) this device must not cause interference and (2)
must accept interference from external sources, notably that liable to cause malfunctions.
In accordance with the requirements of FCC rules, any modification made to this equipment which is not expressly approved by ESSILOR INTERNATIONAL would nullify
the user's right to use this device.
This equipment has been tested and is deemed compliant with the limits imposed for Class-B digital devices according to Part 15 of the FCC rule. Those limits are set so
as to ensure reasonable protection against interference in a residential environment. This equipment generates, uses and may emit radiofrequency energy liable to
interfere with radio communications if the device is not installed and used in strict compliance with manufacturer instructions. However, nothing guarantees the absence of
interference under particular conditions. If this equipment is the source of interference with radio or television reception (this can be confirmed by switching off the device
then turning it back on), the user may be able to eliminate this interference through one or more of the following measures:
Swivel of move the affected receiver or its receiving antenna;
Move the device away from the affected receiver;
Connect the device to a different circuit to that powering the affected receiver;
Request help from the retailer or a qualified radio / television technician.
Copyright
Copyright © 2016 Essilor - Original manual
All rights reserved. All reproduction of the content of this document, whether in part or as a whole, for the purpose of its publication or dissemination by any means and in
any format whatsoever, even free of charge, is strictly prohibited without Essilor's prior written consent.
To Next Page
Loading...
Need help?
General
