3.
2.
3.
1.
2.
3.
Positive value: the diameter will be larger
Press on to confirm.
Once the modification is made, press to return to the work screen.
b. Adjusting the position of the bevel and groove
After edging a lens, if the position of the bevel or groove always seems too close to the front or rear surface, you can adjust it.
To access this menu from the work screen of your edger, select > > > .
The following screen is displayed:
Default bevel position
Press to move the bevel towards the front surface of the lens.
Press to move the bevel towards the rear surface of the lens.
Default polished bevel position
Press to move the polished bevel towards the front surface of the lens.
Press to move the polished bevel towards the rear surface of the lens.
Default groove position
Press to move the groove towards the front surface of the lens.
Press to move the groove towards the rear surface of the lens.
Once the modification is made, press to return to the work screen.
c. Adjusting the diameter of drill-holes
After drilling a lens, if the diameter of the holes always seems too small or too big, you can adjust it according to the diameter of the
drill bit used and the lens material.
To access this menu from the work screen of your edger, select > > > .
The following screen is displayed:
To Next Page
Loading...
Need help?
General
