8
Remove the keys and press .
The wear statistics of the replaced tool are reset to zero.
10. Maintain and clean the tracer-centerer-blocker
This section describes the tracer-centerer-blocker maintenance and cleaning procedures:
Precautions required (p.142)
Clean the reflectors and the lens (p.142)
Clean the tube (p.142)
a. Precautions required
To avoid any incidents, unplug the device before all cleaning operation.
Clean the cover of the tracer-centerer-blocker regularly: use a neutral detergent (e.g.: dishwashing liquid) diluted with water
on a soft cloth.
Never clean the apparatus with chemical products (e.g.: petrols, thinners, solvents).
b. Clean the reflectors and the lens
Dirty or striped reflectors or a lens can cause tracing defects. Be careful and clean them using a soft and dry rag regularly.
Never pour liquid on these parts.
c. Clean the tube
In order not to damage the LED band surrounding the centering chamber, clean the tube using a dry rag without rubbing it.
Never pour liquid on these parts.
11. Maintaining and cleaning the edger
This section describes the procedures for servicing and cleaning the digital system:
Precautions required (p.142)
Clean the GCD module (p.143)
Clean the door (p.143)
Dress the wheels (p.144)
a. Precautions required
To avoid any incidents, unplug the device before all cleaning operation.
Clean the edger covers regularly: use a neutral detergent (e.g. washing-up liquid) diluted with water on a soft cloth.
Clean the touch screen with a dry rag: it should never come into contact with liquid (e.g. water, alcohol, window cleaner).
Service the water recovery and filtration systems regularly.
Never clean the machine with chemical products (e.g.: petrol, thinners, solvents).
Never clean the machine elements (module, etc.) with a wet rag.
No additive should be added to the water in the edger tank. Do not add pyridine.
The module goes back into its initial position.>
To Next Page
Loading...
Need help?
General
