8
7
6
5
4
3
2
1
From the edger’s work screen, select > > > to access the dressing menu.
You can access the dressing menu by pressing on the work screen.
Make sure that the 22 mm accessories (posiblock holder and stop) are installed on the lens clamp shafts.
Select the appropriate dressing cycle:
Glass roughing wheel
Finishing wheel
Polishing wheel
Never dress the polishing wheel twice in a row to avoid possible damage.
Orange dressing stone for the glass roughing wheel
White dressing stone for the finishing wheel
Square dressing stone for the polishing wheel
Insert the dressing stone for the selected cycle between the lens clamp shafts, with the hollow side against the posiblock
holder.
Press to close the clamps.
Close the door.
Press to start the dressing cycle.
Once the cycle is finished, press to open the clamps and remove the dressing stone.
If the dressing stone shows a residual ring, remove it in order not to disrupt subsequent dressing operations.
For each wheel, there is a specific dressing stone, whose icon is displayed on the screen:>
To Next Page
Loading...
Need help?
General
