Feasa 10-F User Manual

FEASA LED ANALYSER
FUNCTIONAL VERSION
Daisy Chain Mode
BusFree - Deactivate any active Analysers
Transmit Receive
busfree OK
Description
This command is used to deactivate any active Analysers on the Daisy Chain Bus. This will
free the Bus to allow an Analyser to be made active. This command should be issued at the
start of a sequence. It is the responsibility of the Controlling Computer to issue commands
and monitor the responses. If an Analyser does not respond within 500mSec then the
Controlling Computer should issue a new BusFree command and report an error.
The Analyser connected to the computer will operate as a standalone unit after the command
is issued.
Example:
The PC transmits busfree to free up the Daisy Chain Bus.
busfree
OK
Back to Index
106

Feasa 10-F Specifications

General

Brand	Feasa
Model	10-F
Category	Measuring Instruments
Language	English