FEASA LED ANALYSER
FUNCTIONAL VERSION
About this Manual
Feasa operates a policy of continuous development. Feasa reserves the right to make changes
and improvements to any of the products described in this document without prior notice.
Feasa reserves the right to revise this document or withdraw it at any time without prior
notice.
This manual is written for models Feasa Functional Led Analysers. The model numbers are
Feasa x-F, Feasa x-FB, Feasa x-LT (where x is the number of fibers either 2,3,5,6,10,20).
The Feasa 20-F is a standard 20 channel Analyser which will test up to 20 LED's while the
Feasa 3-F is a standard 3 channel Analyser testing up to 3 LED's.
The Feasa 20-FB is a High Brightness 20 channel unit which will test up to 20 LED's while the
Feasa 3-FB is a 3 channel High Brightness unit testing up to 3 LED's.
The Feasa 20-LT is a Life Tester 20 channel unit which will test up to 20 LED's in an oven
while the Feasa 3-LT is a 3 channel Life Tester unit testing up to 3 LED's.
The interface on these units is USB or RS232-Serial.
© Copyright 2005-2020 by Feasa Enterprises Ltd. All rights reserved. No parts of this
manual may be reproduced or retransmitted in any form or means, electronic or
mechanical, including photocopying, recording, or any other storage and retrieval
system without prior permission in writing from Feasa Enterprises Ltd. Every effort
has been made to ensure that the information in this manual is accurate. Feasa
Enterprises Limited is not responsible for printing or clerical errors.
2
To Next Page
Loading...
Need help?
General
