16 1 Installing the Printer
1 Installing the Printer
1.1 Checking the Package Contents,
Unpacking the Printer
1. Check that all items listed below are in the box.
Note
• Retain the packaging material and box for future use if there is a possibility that the printer will be moved
over long distances.
This printer
Drum/toner cartridge (2K)
Software pack CD-ROM
Power cord
User guide (This manual)
2. Remove the printer from the box and carry it to the installation location. Ensure that
the installation location is equipped with the following conditions or conditions stated
in “For Installation & Relocation” (P. 9).
• Do not expose the printer to direct sunlight.
• Do not expose the printer to direct draft of air-conditioner or heater.
• Temperature range 10 - 32°C, humidity range 15 - 85% (no condensation). Humidity
should be 70% or below at 32°C, and temperature should be 28°C or below at 85%
humidity.
Note
• Sudden temperature fluctuations can affect print quality. Rapid heating of a cold room or moving the
printer from a location with low humidity/temperature to high humidity/temperature can cause
condensation inside the printer, directly interfering with image transfer. When condensation occurs,
leave the printer alone for at least 1 hour to acclimate to the environment before using it.
3. When the printer is first taken out of the
box, the paper tray of the printer is taped as
shown in the diagram. Remove these
pieces of tape.
To Next Page
Loading...
Need help?
General
