Faxing 275
Discard Size When receiving a document as long as or longer than the paper installed in
your printer, you can set the printer to discard any excess at the bottom of the
page. If the received page is outside the margin you set, it will print on two
sheets of paper at the actual size. When the document is within the margin
and Discard Size is set to Auto Reduction, the printer reduces the
document to fit it onto the appropriate sized paper and discard does not
occur. If Discard Size is set to other than Auto Reduction, the data
within the margin will be discarded.
Auto Redial Setup Number of Redial You can specify the number of redial attempts to make when the destination
fax number is busy, within the range of 0 to 9. If you enter 0, the printer will
not redial.
Redial Interval Your printer can automatically redial a remote fax machine if it was busy.
Intervals from 1–15 minutes can be entered.
Interval Timer You can specify the interval between transmission attempts within the range
of 3 to 255 seconds. The default is 8 seconds.
Dial Type You can select the dialing type.
• PB
• DP (10PPS)
• DP (20PPS)
Prefix Dial You can specify whether or not to set a prefix dial number.
Prefix Dial Number You can set a prefix dial number of up to five digits. This number dials before
any auto dial number is started. It is useful for accessing the Private
Automatic Branch Exchange (PBX).
Fax Cover Page You can set whether to attach a cover page to faxes when sending faxes.
Send Header Prints the sender’s information on the header of faxes.
Select Off to turn this feature off.
Select On to turn this feature on.
Note that if United States is selected for the setting of Region, this option
does not appear on the menu. The setting is fixed to On and cannot be
changed.
For information on the region setting, see "Specifying the Fax Initial Settings
From the Operator Panel" on page 250.
ECM You can set whether to enable or disable the ECM (Error Correction Mode).
Modem Speed You can set the modem speed.
Display Manual Fax Recipients To set whether to display the fax number of the recipient when manually
sending a fax.
Fax Reports Fax Activity You can set whether to automatically print a fax activity report after every 50
incoming and outgoing fax communications.
Fax Transmit You can set whether to print a transmission result after a fax transmission.
Fax Broadcast You can set whether to print a transmission result after a fax broadcast to
multiple locations.
Fax Protocol You can set whether to print the protocol monitor report after a fax
transmission to monitor fax protocol problems.
Option Description
To Next Page
Loading...
Need help?
General
