Chapter 6 General
6.4 Service Mode
6-37
Scanner
Mainte-
nance
White Balance Adjusts the white balance automatically. 6.13.1
Shading Parameter Adjusts the shading factor setting. 6.13.2
Registration Param. Adjusts registration. 6.13.3
Auto Registration
Sets whether to enable the Auto Registration
feature.
6.13.4
Sensor Parameter
Adjusts the power control value of the Feed
Sensor.
6.13.5
Vertical Scan Mag.
Sets the parameters of the magnification for the
slow scanning direction.
6.13.6
Test Pattern Sets the test pattern and parameters. 6.13.7
IIT I/O Check
Checks the input/output of the scanner compo-
nents.
6.13.8
Scan Counter Clear Clears the scan counter. 6.13.9
Carriage Drive_100
Operates the carriage 100 times consecutively,
as an IIT jig for the ORT. If an error is detected,
[Abnormal End] is displayed. Errors can be
detected for [Lamp Error] and [Home Position
Error] only.
6.13.10
Parameter Sets the system data using ChainLink. 6.14
Backup
Data
All Clear Deletes the backup data in SRAM/EEPROM.
6.15
User Clear Deletes the backup data in SRAM/EEPROM.
System Clear Deletes the backup data in SRAM/EEPROM.
User&System Clear Deletes the backup data in SRAM/EEPROM.
System Data Init Deletes the backup data in SRAM/EEPROM.
Document Clear
Deletes the document data in the Flash Memory
for Fax.
Complete Complete Exits the CE mode and restarts the printer. 6.4.4
Table 6-29 Function Names and Descriptions (Fax/Scanner)
Function Description See
To Next Page
Loading...
Need help?
General
