Chapter 6 General
6.14 System Data Setting Parameter
6-83
6.14 System Data Setting Parameter
You can set the system data related to fax and scanner.
Procedure
1 Enter the CE mode. (See "6.4.2 How to Enter the CE Mode".)
2 Use the [T] button to select [Fax/Scanner Diag], and then press the [OK] button.
3 Use the [T] button to select [Parameter], and then press the [OK] button.
4 Change the Chain Link No., and then press the [OK] button.
• Use the [W] or [X] button to move the cursor to left or right.
• Use the [S] or [T] button to change the value of the digit where the cursor is placed.
• Pressing the [OK] displays the setting value for the Chain Link No. you have specified.
5 Change the setting, and then press the [OK] button.
• H is displayed when the value is set.
6 Use the [ (Back)] or [ (Stop)] button to return to the [Fax Scanner Diag] screen.
7 Exit the CE mode. (See "6.4.4 How to Exit the CE Mode".)
Fax/Scanner Diag
Parameter…
Parameter
Chain Link: 000-000
Value (Hex):
Cursor
Cursor
Parameter
Chain Link: 840-001
Value (Hex): 81
Parameter
Chain Link: 840-001
Value (Hex):
H
81
Fax/Scanner Diag
Parameter…
To Next Page
Loading...
Need help?
General
