Chapter 2 Troubleshooting
2.3 Error Code FIP
2-55
FIP1.11 050-130 IOT Remain Zone Fusing Jam
077-106 Exit On Jam
077-108 Exit Off early Jam
077-109 Exit Off Jam
Step Check and Action Yes No
Parts considered to be the cause
ROLL ASSY EXIT (PL17.1.5)
KIT PINCH ASSY L(PL17.1.6)
KIT PINCH ASSY R(PL17.1.7)
Heat Roll [FUSING UNIT] (PL7.1.1)
ROLL ASSY RUBBER (PL15.2.6)
ROLL ASSY REGI PINCH (PL15.2.8)
ROLL REGI PINCH (PL15.2.37)
Transfer Unit [ROLL ASSY-TRANS CRU] (PL6.1.1)
Drum Cartridge [XERO ASSY] (PL8.1.1)
EXIT SENSOR (PL17.1.1)
Regi. Sensor [HVPS] (PL18.2.5)
CLUTCH ASSY EXIT (PL3.1.6)
REGI. CLUTCH (PL15.2.4)
DRIVE ASSY MAIN (PL3.1.1)
PWBA MCU (PL18.2.2)
1
Check the paper transport path
Is there any foreign substances or bits of paper found on
the paper transport path?
Make sure that the FUSING UNIT has cooled down
before performing the operation.
Remove the for-
eign substances
and bits of paper,
etc.
Go to Step 2.
2
Check the paper feed rolls
Are the paper feed rolls (the rolls that are listed among
the parts considered to be the cause) installed properly?
Go to Step 3.
Reinstall the
corresponding
paper feed rolls
3
Check the paper feed rolls
Are the paper feed rolls (the rolls that are listed among
the parts considered to be the cause in sequence)
deformed or worn out?
Replace the cor-
responding paper
feed rolls
Go to Step 4.
4
Check the operation of the EXIT SENSOR
Execute the Diag Digital Input [071-103] to check the
operation of the EXIT SENSOR.
Is the EXIT SENSOR operating normally?
Go to Step 5. Go to FIP2.1
5
Check the Regi. Sensor [HVPS] operation
Execute the Diag Digital Input [071-102] to check the
operation of the Regi. Sensor [HVPS].
Is the Regi. Sensor [HVPS] operating normally?
Go to Step 6. Go to FIP2.2
6
Check the operation of the CLUTCH ASSY EXIT
Execute the Diag Digital Output [071-007] to check the
operation of the CLUTCH ASSY EXIT.
Is the CLUTCH ASSY EXIT operating normally?
Go to Step 7. Go to FIP2.6
To Next Page
Loading...
Need help?
General
