Fujitsu 1FINITY L100 User Manual

7.13
Adding Raman Blade to ROADM Node
In this secon:
7.13.1 Provision Raman Port Connecons
Perform the correct Raman ber cabling connecon as described in Install L160 Raman Cabling.
Note: If L160 blade is not provisioned already, in order to provision refer to Provision L160 Tributary Blade
7.13.1
Provision Raman Port Connections
Prerequisites:
■ Appropriate Raman ber-opc cable connecon must be completed. For more informaon, refer to Install
L160 Raman Cabling.
■ L100 and L160 Blades must be provisioned
This procedure describes how to provision port-connecon between Raman blade and L100 Blade.
Note: L100 Blade Issue 14, FC95453R11-I14, and later blade must be used with L160 Raman blade.
Step 1
Provision the edge port E1 of L100 Blade.
Note: If autoprovisioning is enabled, the E1 port is automacally provisioned.
Command:
% set eqpt shelf 1 slot 0 cardType BDL1-3R11 subslot 0 port E1 admin-status up
pluggableInterfaceType Edge num-lanes 128
Step 2
Provision the client port C1 on the Raman tributary blade.
Note: If autoprovisioning is enabled, the client port C1 is automacally provisioned.
Command:
% set eqpt shelf 101 slot 0 cardType BDL1-3M21 subslot 0 port C1 admin-status up
pluggableInterfaceType Client num-lanes 128
ROADM Turn-Up and Operations
Adding Raman Blade to ROADM Node
277
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only

Fujitsu 1FINITY L100 Specifications

General

Brand	Fujitsu
Model	1FINITY L100
Category	Server
Language	English