To Next Page

To Previous Page

6-1

6. WEB FUNCTIONS

This chapter covers how to access Communication Unit settings, and connection in-

formation. User must login as Administrator to access these functions.

Note: Communication may not be possible if setting are wrong. Settings should be

performed by an experienced administrator. Also, be sure to log out after performing

settings. (refer to paragraph 6.1.1)

6.1 Communication Unit Settings

In the menu bar, click [Settings] to access Basic, PBX, Network, Password, Log for-

warding, Setting saving and loading. For information on [Basic], refer to the Installation

Manual.

6.1.1 Administrator login

Do as follows to login as Administrator.

1. Click the [admin login] button.

2. Enter "Admin" in the Username box and "01234567" in the Password box.

The factory-set Administrator password is 01234567. To change the password,

see paragraph 6.1.13. The username cannot be changed.

Note: If you forgot the Administrator password, consult your dealer for advice.

This operation requires restoration of the default settings.

3. Click the [Login] button. Log, Settings, Device, Selftest appear in the menu bar,

and [login] is replaced with [logout].

4. To logout after completing all settings, click the [admin logout] button. Log, Set-

tings, Device, Selftest disappear from the menu bar, and [logout] is replaced with

[login].

Note: The system automatically logs you out when there is no key operation in 15 min-

utes.

Furuno FELCOM 250 User Manual

Other manuals for Furuno FELCOM 250