3. SETTINGS FOR HANDSET
3-19
3.6 System Messages
3.7 Device List
If an alarm occurs in a unit connected in the same network, the handsets sounds an
alarm tone and an alert information window displays. The alarm icon ( ) also ap-
pears at the status bar on the upper part of the screen.
1) In the alert information window, select [New SysMsg] and press the Enter key.
The most recent system messages appears. A maximum of 10 system messages
can be saved, however the messages are erased when the power is turned off.
2) If there are more than two alert messages, press W and X to cycle through the mes-
sages. Use W to go back one message, and X to go forward one message.
3) Press the Enter key to close the message.
Note: You can also display system messages with the [Sys Msg] icon in the main
menu.
The Device list displays a list of all devices (communication unit, handset, incoming in-
dicator).
1) At the idle screen, press the Enter key to open the main menu.
2) Press W, T to select the [Device] icon and press the Enter key. The message "De-
tecting" appears while the list is being prepared. When the search is completed, the
[Device list] screen appears.
3) Press the key to close the menu.
No. of messages/
Total messages saved
Communication Unit
Incoming Indicator
Handset
To Next Page
Loading...
Need help?
General
