Clock
Syncing the Time with GPS
Each time you turn on the device and acquire
satellites, the device automatically detects your
time zones and the current time of day. You can
also manually sync the time with GPS when you
change time zones, and to update for daylight
saving time.
1 From the watch face, hold UP.
2 Select Settings > System > Time > Sync With
GPS.
3
Wait while the device locates satellites (
Acquiring
Satellite Signals, page 36
).
Setting the Time Manually
1 From the watch face, hold UP.
2 Select Settings > System > Time > Set Time >
2 Select Stopwatch.
NOTE: You may need to add this item to the
controls menu (
Customizing the Controls Menu,
page 29
).
3 Select START to start the timer.
4 Select BACK to restart the lap timer
1
.
Manual.
The total stopwatch time continues running.
3 Select Time, and enter the time of day.
Setting an Alarm
You can set up to ten separate alarms. You can set
each alarm to sound once or to repeat regularly.
1 From the watch face, hold UP.
2 Select Alarm Clock > Add Alarm.
3 Select Time, and enter the alarm time.
4 Select Repeat, and select when the alarm
should repeat (optional).
5 Select Sounds, and select a type of notification
(optional).
6 Select Backlight > On to turn on the backlight
with the alarm.
7 Select Label, and select a description for the
alarm (optional).
Deleting an Alarm
1 From the watch face, hold UP.
2 Select Alarm Clock.
3 Select an alarm.
4 Select Delete.
Starting the Countdown Timer
1 From any screen, hold LIGHT.
2 Select Timer.
NOTE: You may need to add this item to the
controls menu (
Customizing the Controls Menu,
page
29
).
3 Enter the time.
4 If necessary, select Restart > On to automatically
restart the timer after it expires.
5 If necessary, select Sounds, and select a type of
notification.
6 Select Start Timer.
Using the Stopwatch
1 From any screen, hold LIGHT.
To Next Page
Loading...
