Hardi HC 9600 User Manual

4 - System setup
102
New Pattern - Straight
Select Pattern
System defaults pattern type to last used. Press the pattern icon to select a different pattern.
• Implement Width (from Implement Setup).
• Guidance Width input box.
• Enable Tramlines checkbox. See “Tramlines” on page 117.
• Change Pattern.
Press to accept. You will automatically return to the Map screen.
Create AB line using 2 points
• Press to mark point A.
A green ball appears on the map screen where point was placed.
• Button is grayed out until you drive a minimum of 100 feet (30 meters).
• Pause - Press to pause path during path creation.
• Resume - Press to resume path during path creation.
• Cancel - Press to cancel path during path creation.
• Press to mark point B. The AB line appears on the map screen and point B is marked with a red
ball.
Create AB line using Current Location and Heading
• uses current location and heading, line extends 1 mile (1.6 km) before and after the A point
(recommend vehicle having forward motion to get a good heading).
Create AB line using Current Location and Inputting Heading
• uses current location and input heading, line extends 1 mile (1.6 km) before and after the A
point.
New
Pattern
Change
Pattern
Select Pattern
Straight SmartPath Pivot
Adaptive Curve Identical Curve

Hardi HC 9600 Specifications

General

Brand	Hardi
Model	HC 9600
Category	Controller
Language	English