Hardi HC 9600 User Manual

4 - System setup
124
Configuration Setup
The Configuration Setup screen appears. Screen
will vary depending on configuration. Process may
include the following tasks:
Configuration Settings:
• Equipment Settings
Equipment configurations should adjust
settings at the Equipment Configuration
Settings screen.
• Speed Input
For more information, see “Speed Input
Settings” on page 89.
• Automatic Swath Control (if using
AutoSwath)
For more information, see “Automatic Swath
Control (AutoSectionControl)” on page 90.
• Vehicle Offsets
Adjust GPS offsets for the Antenna Tab and the Hitch Tab. For more information, see “Vehicle Offsets” on page 91.
• Offsets
For more information, see “Swath Section Offsets” on page 92.
• Norac UC5
Adjust AutoTerrain/AutoHeight settings - see also “SafeTrack/IntelliTrack” on page 124. For further information, please
refer to the AutoTerrain/AutoHeight UC5 instruction books.
SafeTrack/IntelliTrack
For ISOBUS the Implement Modeling can be
selected. This allows display to accurately calculate
path of a sprayer equipped with steering.
Configuration
Your Specific
Configuration
Configuration Setup
Vehicle
JD 4630
Vehicle
Offsets
Norac
UC5
Speed
Input
Auxiliary
Input
Automatic
Swath Control
Equipment
Settings
Offsets
Implement: Hardi Commander Controller: Hardi ISOBUS
Full Swath:
Sections:
Device:
Make:
Structure Label:
Configuration
Select Your Specific
Configuration
Offsets
Implement Offsets: Hardi Commander
Implement
Liquid with Hardi Sprayer
Implement Modeling
Implement Provides a Rear Hitch
Hitch to Axle
Distance
Lateral Offset from Centerline
Left
Implement Type
Standard
Front Hitch to Rear Hitch
Implement Rear Hitch
Heading
Aggressiveness
Boom Height

Hardi HC 9600 Specifications

General

Brand	Hardi
Model	HC 9600
Category	Controller
Language	English