Hardi HC 9600 User Manual

7 - Fault finding
188
If an operator selects a configuration that has a , the Module Changed/Missing
window will appear, verifying that you want to load the configuration.
If you press , the configuration will be updated with the modules currently being
used.
ISOBUS Configuration Mismatch
If the HARDI® C2C Module is found but the data in
the Module and the selected configuration does
not match, it will not be possible to proceed with
the operation selection.
This fault appears when the boom width and/or
the number of sections does not match in the
setup in the JobCom and the display.
Select another matching configuration or create a
new one with the same data in the JobCom and
display.
After changing the data in the JobCom the power
of the JobCom and ISOBUS C2C should be
powered On/Off to reload the new settings.
It might also be necessary to clear the Universal
Terminal in the V T menu.
÷
NOTE! This failure also appears if Task Controller has not been selected in the ISOBUS Settings menu. See “Enable
Universal Terminal and Task Controller” on page 45.
The selected configuration contains a module
that appears to have been replaced. If this is the
case, press accept. Otherwise, press cancel and
choose or create another configuration.
Module Changed/Missing
Operating Configuration Selection
Alpha 4100
Equipment Name
Vehicle Alpha 4100
Device Hardi
Hardi C2C Module: ISOBUS configuration mismatch
Container
Device
Main Tank
Boom Height
Norac UC5 Module
Boom Height

Hardi HC 9600 Specifications

General

Brand	Hardi
Model	HC 9600
Category	Controller
Language	English