● Warning Messages 6-49
6.7 Warning Messages
● If any communication is in error, the associated warning message appears.
● Note the message to confirm the error and then take remedial action as appropriate for
the indicated error code.
Error code table
Error
code
Name Description Check
001
Transmission code
error
● The transmitted code was not defined
for communication use.
● The transmitted message had an
illegal structure.
Check the baud rate and
transmission code.
002
Print specifications
code error
The print specifications data value was
illegal.
Check the print
specifications
communication text.
003
Print character code
error
The maximum value was exceeded by
the number of characters for printings
that could be received as one item.
Check the printings
communication text.
004 Item number error
The item number code value was
illegal.
Check the printings
communication text.
005 Header error The header value was illegal. Check the header.
006
Ready-for-
reception error
● An attempt was made to establish
communication while the "not ready
for reception" state prevailed.
● "Apply" key and message window
were both displayed.
● "Off-line fixed" has been set in
Communication environment.
● Communication monitor screen was
displayed.
Check the transmission
timing.
008
Print specifications
code error
The maximum value was exceeded by
the print specifications data.
Check the print
specifications
communication text.
009 ETX code error The ETX code position was illegal.
Check the transmission
procedure and ETX
code.
010 DLE code error The DLE code position was illegal.
Check the transmission
procedure and DLE
code.
011 STX code error The STX code position was illegal.
Check the transmission
procedure and STX
code.
012 ENQ code error The ENQ code position was illegal.
Check the transmission
procedure and ENQ
code.
013 ESC code error The ESC code position was illegal.
Check the transmission
procedure and ESC
code.
Print description
Column1 Column2 Column3
Shut
down
Manual
To Next Page
Need help?
General
