7-39 ● Long-term Shutdown
7.15.2 Startup process to be performed after long-term shutdown
(1) Overview
● This operation is the work for draining the makeup ink which cleaned the ink circulation
system at the long-term shutdown of the IJ printer and refilling it with the ink.
● To completely drain the makeup ink from the circulation system, you should charge the
circulation system with the ink, drain the ink, and fill the ink again into the system.
(2) Operating procedure
Remove the nozzle rubber seal.
1
Press the Ink stream adjustment key and then the
Start/Continue key.
2
1. ck to see that the makeup ink is ejecting from the nozzle.
If not ejecting, repair it according to "Table 1.
Repairing the printer after the long-term shutdown."
2. If it is ejecting, check the stream position. See "7.7 Adjusting the
Ink Stream Position" for the method.
Notice
Open the "Circulation control" screen, and press the
Process after long-term shutdown key and then the
Start/Continue key.
3
Follow the on-screen instructions for the operation.
● Repeat the same procedure as in "7.5 Ink Replacement" twice.
4
In the case where you cannot perform the drainage or refill of the
ink, repair it according to "Table 1. Repairing the printer after the
longterm shutdown."
Notice
Start
up
Start/
Continue
Eject ink
(Goes to Standby)
Next
menu
Circulation control Status: Stop
Prev.
menu
Cleaning stop No-cleaning stop
Ink replacement
Ink filter
replacement
Nozzle backwash
Process prior to
long-term shutdown
Process after
long-term shutdown
Gutter cleaning
Cancel
Com=0
To Next Page
Loading...
Need help?
General
