7-1 ● Circulation System Operating and Adjustment Procedures
7. Circulation System Operating and
Adjustment Procedures
● Never drain the ink or makeup ink waste solution into public
sewer systems. Waste disposal must comply with all appropriate
regulations.Consult the appropriate regulatory agency for further
imformation.
● Exercise care not to inadvertently disconnect, forcibly pull, or
bend a piping tube. Since the ink and makeup ink in some
portions of piping tubes are pressurized, they may splash and
enter your eyes or mouth or soil your hands or clothing.
If the ink or makeup ink, enters your eyes or mouth, immediately
flush with warm or cold water and see a physician.
● When charging a refill of ink or makeup ink, exchanging ink, or
otherwise handling ink or makeup ink, take enough care not to
spill ink or makeup ink. If you spill any ink or makeup ink by
mistake, wipe it off neatly and promptly with wiping paper or
something similar. Do not close the maintenance cover until you
make sure that the portion you have just wiped is completely dry.
You must pay particular attention when you have spilled ink or
makeup ink inside the printer and it is not completely dry. Why?
Because vapors of ink or makeup ink will stay inside the printer
and may catch on or cause a fire.
If you find it hard to wipe the printer when energized, stop it with
the maintenance cover open. Power it down, then wipe it off again.
● Should you find a leak of ink or makeup ink inside the printer
while the printer is running or being maintained, wipe it off
promptly with wiping paper or something similar. Then, with the
maintenance cover open, stop the printer, power it down, and
repair the leak.
A continued run with a leak of ink or makeup ink will cause an
anomaly, resulting in abnormal printing.
Ink and makeup ink are flammable. They may therefore catch on
or cause a fire.
● If you wish to receive ink drops in a beaker, for a printing test for
example, use an electrically conductive beaker and connect the
beaker securely to the ground.
Do not let the tip of the printing head enter the beaker.
Ink drops used for printing are electrically charged.
An ungrounded beaker has a gradually rising charge, possibly
catching on or causing a fire.
WARNING
● When handling the ink or makeup ink, which contatins organic
solvent, observe the following precautions.
Wear protective gloves and safety goggles to avoid direct skin
contact. If skin is contacted, thoroughly clean it with soap and
warm or cold water.
When transferring the ink or makeup ink to or from a bottle,
exercise care not to let it come into contact with the printer or
surrounding articles. If anything is contacted, wipe it clean with
a cloth moistened with ethyl alcohol.
Notice that there is a possibility that a cap and a content may fly
with inner pressure when opening the container of ink and a
solvent.
Please open a cap of container an even place.
CAUTION
1
2
3
4
To Next Page
Loading...
Need help?
General
