Honda 2004 CRF250X Service Manual

FRONT WHEEL/SUSPENSION/STEERING
Hold the fork damper on level ground while the fork
damper piston rod is fully extended and com-
pressed by hand.
Release the fork damper pi sto n rod then check that
it extends to its maximum length.
If the fork damper piston rod does not extend to
maximum, bleed the fork damper again.
Wipe the oil completely off from the fork damper .
Compress the fork piston rod 200 - 250 mm (7.9-
9.8 in) from fully extended and hold the fork damper
in an upright position for 10 minutes.
There should be no oil leaking from the fork damper
spring chamber and piston rod .
If oil leaks fr om th e spring chamber or piston rod,
replace the fork damper assembly .
Hold the fork damper on level ground and release
the fork damper piston rod, then check that the pis-
ton rod extends to its maximum length.
FORK DAMPER INSTALLATION/ PREPARATION
[f the outer tube and slider (fork) have not been dis-
assembled, turn the fork upside down for 20 min-
utes and drain the oil from the inside of the oute r
tube and slider complete ly (7.1 cc at 20 °C/ 68 O F) .
Amount of fork oil left in the fork
(without damper and spring)
unit: cc
r-
minute
5 10 20 35 55
B5 145
30186
7.1 5.9 4.7 4.2 3.5 3.5 3.5
~
20/68 10 .6 B.2
II 5.9 5.6 4.7 4.7
b
r, Oi50
11.8 B.3 n
6.2 5.B 4.9 4.8
,
0/32 12.9 10.6 9.4 B.2 7.9 7.1
5.9
,
<
,
0
i
"
FORK DAMPER
F ORKDAM~
200-250 mm
(7.9 - 9.8 in)
PISTON ROD
OUTER TUBE/SUDER
1 J
o "C (32 OF)
/ 10 ' C 150 ' F)
~
"
20 °C (68 OF)
"
"
.: L I 30 ' CIB6 ' F)
\\.
"
~== ~~~ i -:c=
•
•
·
•
•
•
" "
" "
,.
••
..
',.,.n..,,,mo
,-,
• •
13-25

Honda 2004 CRF250X Specifications

General

Brand	Honda
Model	2004 CRF250X
Category	Motorcycle
Language	English