Honda 2004 CRF250X Service Manual

Major adjustments can be made with the in-line
cable adjuster located behind the number plate .
Loosen the l ock nut and turn the adjuster.
T ighten the lock nut.
If proper free play cannot be obtained using both
procedu r es or the clutch slips during the test ride,
disassemble and inspec t the clutch (page 10-9).
CONTROL CABLES
Remove the dust cover and throttle housing bolts .
Turn
the handleba r to the right fully and remove the
throttle hous i ng from the handlebar.
Disconnect the throttle cable end from the throttle
pipe.
Remove the clutch cable and adjuster.
Disconnect the clutch cable upper end and the hot
start cable upper end from the levers.
It IS nor necessary Thoroughly lubrica te the cable ends with a commer-
to lubricate the cially available cable lubricant.
entire cable Ap p ly grease to the clutch cable end adjuste r inside
surface and install it onto the clutch lower holder.
If the clutch lever, hot start lever and th rottle opera-
tion is not smooth, replace the cable.
Be
sure the throttle returns freely from fully open to
fully closed automatically, in all steering positions.
EXHAUST PIPE/MUFFLER
EXHAUST SYSTEM INSPECTION
Check the joint band bolt and joint nut for looseness
and exhaust gas leaks.
Tighten each bolt and nut of the exhaust system to
the specified torque.
TORQUE:
Exhaust pipe joint nut :
21 N 'm (2.1 kgf · m. 1Slbf.ft )
Muffl er jO int band bolt :
21 N·m (2.1 kgf ·m. 1Slbf.ftl
MAINTENANCE
CABLE END ADJUSTER
3-29

Honda 2004 CRF250X Specifications

General

Brand	Honda
Model	2004 CRF250X
Category	Motorcycle
Language	English