Honda 2004 CRF250X Service Manual

MAINTENANCE
Make sure that the master link pins are insta lled
properly.
Measure the master link pin length projected from
the plate .
STANDARD LENGTH:
1.15 - 1.55 mm (0 .045 - 0.061 in)
Slake the master link pins.
MAS TE R LINK PINS
Make sure that the pins are staked properly by mea- ~== == =============~
suring the diameter of the staked area using a slide SLIDE CALIPER
caliper.
DIAMETER OF THE STAKED AREA:
5.50 - 5.80 mm (0.217 - 0.228 in)
A drIVe cham wnh a After staking, check the staked area of the master ~=================~
c/lfrtype master Imk link for cracks.
must not be used. If there is any cracking, replace the master link, 0 -
rings
and plate.
DRIVE CHAIN SLIDER
CHAIN SLIDER
3-24
Inspect the drive chain slider for excessive wear.
SERVICE LIMIT: 5 mm (0 .2 in) from upper surface
I NOTICE I
If the chain slider becomes worn to the swingarm,
the chain will wear against the swingarm , damaging
the chain and swingarm.
GOOD
NO GOOD
CRACKED
CHAIN
SLIDER

Honda 2004 CRF250X Specifications

General

Brand	Honda
Model	2004 CRF250X
Category	Motorcycle
Language	English