Honda 2004 CRF250X Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
FRONT VISOR
REMOVAL/ INSTALLATION
Remove the bolts and front v isor .
Remove the headlight 2P connector from clamp.
Disconnect the headlight 2P connector.
Connect the headlight 2P connector.
Clamp the headlight 2P connecto r securely.
Install the front viser by aligning its holes with the
tabs on the steering stem.
Install and tighten the bolts securely.
SUB-FRAME
REMOVAL
Remove the following:
- Radi ator reserve tank (page 6-9)
- Battery (page 16-6)
-
Air cleaner housing (page 5-7)
Remove the wire band and main relay ('04, '05 only)
from sub-frame.
Remove the siphon and reserve tank overflow
hoses from the rear fender.
Slide the rubber boot off, disconnect the taillight 2P
connector ('04, '05) or wire c onnectors (after '05).
Remove the wire band and ICM from rear fender.
FRONT VISOR
'/
2P CONNECTOR HOLES
e) MAIN RELAY r0 4, '05)
2P CONNECTOR OR ~ ...
WI RE CONNECTORS
2-5

Honda 2004 CRF250X Specifications

General

Brand	Honda
Model	2004 CRF250X
Category	Motorcycle
Language	English