Honda 2004 CRF250X Service Manual

IGNITION SYSTEM
IGNITION CONTROL MODULE (lCM)
REMOVALIINSTALLA TION
Remove the side covers (page 2-3),
Remove the
battery (page 16- 6) .
Disconnect
the ICM 6P connectors and wire connec-
tor.
Remove the leM from the rubber case.
ROI.Jt8 the WIres Installation is in the reverse order of remo val.
and harness
property (page ,.
23).
IGNITION TIMING
17-8
• The ignition timing is factory preset and only
needs to be checked when an electrical system
component is replaced.
Warm up the engine to normal operating tempera -
ture.
Stop the engine and remove the timing hole cap.
Connect the timing light to the direct ignition coil
connector wire.
Connect a tachometer .
Read the
instruction for timing light operation .
Start the engine and hold it at 1,700 ± 100 rpm while
pointing the timing light towards the index mark.

Honda 2004 CRF250X Specifications

General

Brand	Honda
Model	2004 CRF250X
Category	Motorcycle
Language	English