Honda 2004 CRF250X Service Manual

MAINTENANCE
AIR CLEANER
3-10
Open the air deaner housing cover.
Remove the air cleaner retaining bolt.
Remove the air cleaner assembly while turning it as
shown.
Remove the air cleaner element from the element
holder .
Thoroughly wash the air cleaner in clean nonflam-
mable or high flash-point cleaning solvent.
Then wash the element again in a solution of hot
water and dishwashing liquid soap.
Clean
the inside of the air cleaner housing.
After cleaning, be sure there is no dirt or sand
trapped between the inner and ouler layer of the
cleaner.
Wash again if necessary.
Allow the air cleaner to dry thoroughly.
After drying, soak the air cleaner in clean Pro Honda
Foam Filter
Oil or an equivalent.
Apply air filter oil to the entire surface of the air
cleaner and
rub it wi th both hands to saturate the
element with oil.
Gently squeeze out excess oil. It is important not to
over-oil , or under-oil the element.
Apply a thin coat of Pro Honda Filter Grease or an
equivalent to the sealing surface.
Assemble the air cleaner element and element
holder.
Hook the element hole onto the holder tab.
RETAINING BOLT
ELEMENT
HOLDER
AIR CLEANER
ASSEMBLY
AIR CLEANER
ELEMENT
RETAINING BOLT
Squeeze
~ , - ~ - Dey - W - ~
, ,
Wash in
non-flammable
solvent
elEMENT
HOLDER
Soak
(Pro
Honda Foam Filter
Oil
or equivalent)
TAB

Honda 2004 CRF250X Specifications

General

Brand	Honda
Model	2004 CRF250X
Category	Motorcycle
Language	English