16
Setting the Interfaces
Using Autosetup
Using Autosetup
Description The Autosetup function allows you to speed up the configuration of the
instrument when making PDH, SDH or SONET measurements.
Autosetup will search the interface chosen on the display
and attempt to configure the instrument to match the received signal.
Autosetup will detect ATM or any of the PRBS patterns the transmitter
can generate. ATM is considered to be a payload of PDH or SDH.
Both MONITOR and TERMINATE modes are tried in the search for a
received signal.
HOW TO: 1 Connect the HP 37717C to the network and select the required
interface on the HP 37717C.
2 Press .
The display will show an Autosetup HELP page.
PDH Input
In PDH there are three framing possibilities for 140 Mb/s, 34 Mb/s, 8 Mb/
s and 2 Mb/s, (34Mb/s, DS3, 2M and DS1 for Option 110) namely
Unframed Framed and Structured.
RECEIVE
RECEIVE
AUTO SETUP
OTHER
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
