HP 5830 series User Manual

95
Upgrading software
Upgrading software includes upgrading the BootWare and system software. Each time the switch is
powered on, it runs the BootWare image to initialize hardware and display hardware information, and
then runs the system software image (called the "boot file" in software code) so you can access the
software features, as shown in Figure 32.
Figure 32 System startup process
FIPS compliance
In Release 1118 and later versions, the device supports the FIPS mode that complies with NIST FIPS 140-2
requirements. Support for features, commands, and parameters might differ in FIPS mode and non-FIPS
mode. For more information about FIPS mode, see Security Configuration Guide.
Software upgrade methods
You can upgrade system software by using one of the following methods:
U
pg
radin
g
method Software t
yp
es Remarks
Upgrading from the CLI:

HP 5830 series Specifications

General

Brand	HP
Model	5830 series
Category	Switch
Language	English