HP 5830 series User Manual

54
Accessing the device through SNMP
You can use an NMS to access the device MIB and perform GET and SET operations to manage and
monitor the device. The device supports SNMPv1, SNMPv2c, and SNMPv3, and can work with various
network management software products, including IMC. For more information about SNMP, see
Network Management and Monitoring Configuration Guide.
By default, SNMP access is disabled. To enable SNMP access, log in to the device through any other
method.
Configuring SNMP login
Connect the PC (the NMS) and the device to the network, making sure they can reach each other, as
shown in Figure 21.
Figure 21 Network diagram
IMPORTANT:
This document describes only the basic SNMP configuration procedures on the device. To make SNMP
w
ork correctly, make sure the SNMP settin
g
s (includin
g
the SNMP version) on the NMS are consistent with
those on the device.
Prerequisites
• Assign an IP address to a Layer 3 interface on the device.
• Configure routes to make sure the NMS and the Layer 3 interface can reach each other.
Configuring SNMPv3 settings
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the SNMP agent.
snmp-agent
Optional.
By default, the SNMP agent is
disabled.
You can enable SNMP agent with this
command or any command that
begins with snmp-agent.

HP 5830 series Specifications

General

Brand	HP
Model	5830 series
Category	Switch
Language	English