45
Logging in to the Web interface
The device provides a built-in Web server for you to configure the device through a Web browser. Web
login is by default disabled.
To enable Web login, log in through the console port, and perform the following configuration tasks:
• Enable HTTP or HTTPS service.
• Configure the IP address of a Layer 3 interface, and make sure the interface and the configuration
terminal can reach each other.
• Configure a local user account for Web login.
The device supports HTTP 1.0 and HTTPS for transferring webpage data across the Internet.
HTTPS uses SSL to encrypt data between the client and the server for data integrity and security, and is
more secure than HTTP. You can define a certificate attribute-based access control policy to allow only
legal clients to access the device.
HTTP login and HTTPS login are separate login methods. To use HTTPS login, you do not need to
configure HTTP login.
Table 17 sh
ows the basic Web login configuration requirements.
Table 17 Basic Web login configuration requirements
Ob
ect Re
uirements
Device
Configure an IP address for a Layer 3 interface.
Configuring routes to make sure the interface and the PC can reach each other.
Perform either or both of the following tasks:
• Configuring HTTP login (not supported in FIPS mode)
• Configuring HTTPS login
PC
Install a Web browser.
Obtain the IP address of the device's Layer 3 interface.
FIPS compliance
In Release 1118 and later versions, the device supports the FIPS mode that complies with NIST FIPS 140-2
requirements. Support for features, commands, and parameters might differ in FIPS mode and non-FIPS
mode. For more information about FIPS mode, see Security Configuration Guide.
HTTP is not supported in FIPS mode.
Unless otherwise stated, the device is operating in non-FIPS mode in the following configuration
examples.
To Next Page
Loading...
Need help?
General
