HP 5830 series - Setting the DSCP Value for Outgoing Telnet Packets When the Device Acts as the Telnet Server

39
Ste
p
Command Remarks
6. Configure the type of terminal
display.
terminal type { ansi | vt100 }
Optional.
By default, the terminal display
type is ANSI.
7. Set the maximum number of lines
to be displayed on a screen.
screen-length screen-length
Optional.
By default, a screen displays 24
lines.
A value of 0 disables the function.
8. Set the size of command history
buffer.
history-command max-size
value
Optional.
By default, the buffer saves 10
history commands.
9. Set the idle-timeout timer.
idle-timeout minutes [ seconds ]
Optional.
The default idle-timeout is 10
minutes for all user interfaces.
The system automatically
terminates the user's connection if
there is no information interaction
between the device and the user
within the timeout time.
Setting idle-timeout to 0 disables
the timer.
10. Specify a command to be
automatically executed when a
user logs in to the user interfaces.
auto-execute command
command
Optional.
By default, no automatically
executed command is specified.
The command auto-execute
function is typically used for
redirecting a Telnet user to a
specific host. After executing the
specified command and
performing the incurred task, the
system automatically disconnect
the Telnet session.
Setting the DSCP value for outgoing Telnet packets when the
device acts as the Telnet server
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Set the DSCP value for
outgoing Telnet
packets when the
device acts as the
Telnet server.
• On a Telnet server running IPv4:
telnet server dscp dscp-value
• On a Telnet server running IPv6:
telnet server ipv6 dscp dscp-value
The default is as follows:
• 48 for a Telnet server running
IPv4.
• 0 for a Telnet server running IPv6.