HP 83751A User Manual

I
-
I
-
Specifications and Options
Options
Option 1EE - Source
Module Connector and
Extension Cable
If Option IEE is ordered, source module interfacing hardware is added.
This includes a connector on the rear panel and an extension cable that
allows the mm-wave module to be positioned in front of the sweeper. This
option provides direct frequency and power level control of HP 83550 series
millimeter-wave source modules from the front panel of the sweeper. HP
83751A and HP 83752A sweepers require external amplification to drive
source modules. High power sweeper models HP 83751B and HP 83752B can
directly drive source modules.
Mechanical Options
There are three mechanical options available for the sweeper. If these options
were not ordered with the original shipment, and are now desired, they can
be ordered from the nearest Hewlett-Packard office using the part numbers
included in each of the following descriptions.
Option ICM Rack Mount Ordering Option ICM adds a rack mount kit without handles. The HP part
Kit without Handles number for the rack mount kit without handles is 5062-3977.
Option 1CP - Rack Mount
Ordering Option 1CP adds a rack mount kit with handles. The HP part
Kit with Handles
number for the rack mount kit with handles is 5062-3983.
Option AX2 - Portable
Handle and Front-panel
Cover
Ordering Option AX2 adds tilt-bail handle, rubber bumpers, rear feet and a
protective front panel cover for Eeld test applications where portability is
desired. Complies with MLT-28800E Class 5 Style D. The HP part number
for the portability kit is 5063-0092.
17-20

HP 83751A Specifications

General

Brand	HP
Model	83751A
Category	Blower
Language	English