I
-
I
-
If
you
have
a
problem
If you have a problem while performing the operator’s check, check the
following list of commonly encountered problems. If the problem you have
encountered is not here, contact the nearest Hewlett-Packard office for
assistance.
If
the
self-test
fails
The self-test has failed if the message that appears when it is done, is
anything except
Full Test.
PHSSED.
q Make sure all external cables are disconnected from the sweeper and run
the self-test again.
q If the test still fails, send the instrument to an HP service center for repair,
including a description of the failed test and any other error messages.
NOTE
If you need to ship your sweeper, remove the front handles (if so equipped) and use the original
packaging (or comparable).
l-10
To Next Page
Loading...
General