I
-
I
-
Power
Cables
The line power cable is supplied in one of several configurations, depending
on the destination of the original shipment.
Each instrument is equipped with a three-wire power cable. When connected
to an appropriate AC power receptacle, this cable grounds the instrument
chassis. The type of power cable shipped with each instrument depends on
the country of destination. See Figure 7-12, “Power Cable and Line (Mains)
Plug Part Numbers”, for the part numbers of these power cables. Cables
are available in different lengths and some with right-angle plugs to the
instrument. Check with your nearest Hewlett-Packard service center for
descriptions and part numbers for these cables.
NOTE
There is no line voltage selector switch on the instrument. The line module will automatically switch
between 110 and 220 Vat as needed.
7-29
To Next Page
Loading...
General