To Next Page

To Previous Page

Operating a Master/Slave Setup

To set up the master sweeper

For

stepped

measurements.

Set the sweep mode to stepped by pressing

(GiF]

SWEEP MODE $ , and

then pressing the

key until the display reads:

Si>Jeep=

St.

lzt:tr,t.

Set the number of points by pressing

@iE)

POINTS and entering the

desired number of points.

NOTE

The master and slave sweepers must have identical sweep mode, number of points, and sweep time

settings. Therefore, the values entered here must also be entered into the slave sweeper.

6-5

Questions and Answers:

Need help?

Do you have a question about the HP 83751A and is the answer not in the manual?

HP 83751A Specifications

General