HP 8559A User Manual

Page 1 - 3:
Table 1-1. HP 85596 Specifications (1 of 4)
2236A & Below Change " Residual FMw specification to read as follows:
less than 1 kHz p
- p for a time interval less than or equal to
.O1
sec, 100/120 line voltages; less than 2 kHz p - p, 220/240
line voltages.
Delete the following under
" Maximum Input (without damage)
Levelstt :
Peak Pulse Power
+50
dBm (100W, 10 microsecond pulse width, 0.01% duty cycle)
with input attenuation
>=30 dB.
Change
"Gain Compression
w
specification to read as follows:
Gain compression
is less than 0.5 dB for a 0 dBm input level
with
0 dB input attenuation.
Under
*'Display Fidelity
w
, change the Linear specification to read
as follows:
<+
- 0.1 division over full 8 division deflection.
Change
" Humidity Range (Operating) " to read as follows:
<95% R.H. 0 - degrees C to +40-degrees C.
Change "EMIft to read as follows:
Conducted and radiated interference
is within the requirements
of methods
CEO3 and RE02 of MIL STD 461A, VDE 0871 and CISPR
Publications
1, 2, and 4.
2320A & Below Change " Residual FMw specification to read as follows:
less than 1 kHz p
- p in 0.1 second.

HP 8559A Specifications

General

Brand	HP
Model	8559A
Category	Measuring Instruments
Language	English