HP A5800 Series Installation Guide

50
Table 10 Boot menu options
Item
Description
1. Download application file to flash
Download a software package file to the Flash memory.
2. Select application file to boot
Select the software package file to boot.
3. Display all files in flash
Display all files in the Flash memory.
4. Delete file from flash
Delete files from the Flash memory.
5. Modify BootRom password
Modify the Boot ROM password.
6. Enter BootRom upgrade menu
Access the Boot ROM update menu.
7. Skip current system configuration
Start the switch with the factory default configuration. This is a one-
time operation and does not take effect at the next reboot. You use
this option when you forget the console login password.
8. Set BootRom password recovery
Disable or enable the Boot ROM password recovery function. By
default, Boot ROM recovery is enabled. You can disable this
function to protect system security.
9. Set switch startup mode
Set the startup mode of the switch to normal (full) mode or fast
mode, as described in ―Changing the startup mode.‖
0. Reboot
Restart the switch.
 If you perform no operation or press a key other than Ctrl + B within five seconds, the system
automatically starts up when the remaining time becomes zero, and displays the following
information:
Starting to get the main application file--flash:/A5800_release.bin............
The main application file is self-decompressing................................
...............................................................................
...............................................................................
...............................................................................
...............................................................................
..........................Done!
System is starting...
Board checking.......................LSW15856C
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Please check leds....................FINISHED!
User interface aux0 is available.
Press ENTER to get started.
Press Enter at the prompt, and you can configure the switch when the prompt <HP> appears.

HP A5800 Series Specifications

General

Brand	HP
Model	A5800 Series
Category	Switch
Language	English