HP Data Protector A.06.11 Integration Guide

3. In the Start Backup dialog box, select the Network load option. For information
on network load, click Help.
Note that only the Full backup type is supported.
In the case of a ZDB-to-disk or a ZDB-to-disk+tape session, specify the Split
mirror/snapshot backup option. See Figure 28 on page 101.
NOTE:
You can run a ZDB-to-disk or a ZDB-to-disk+tape session only if the
Track the replica for instant recovery option is selected in the backup
specification.
Figure 28 Selecting ZDB to disk or ZDB to disk+tape session when
starting an interactive backup
Click OK.
Starting a backup using the CLI
To start an Oracle ZDB-to-tape or ZDB-to-disk+tape session using the Data Protector
CLI, run:
omnib -oracle8_list Name
To start an Oracle ZDB-to-disk session using the Data Protector CLI, run:
omnib -oracle8_list Name -disk_only
where Name is the name of the backup specification. For more information on the
omnib command, see its man page or the HP Data Protector command line interface
reference.
Zero downtime backup integration guide 101

HP Data Protector A.06.11 Specifications

General

Brand	HP
Model	Data Protector A.06.11
Category	Software
Language	English