5. At this point, you can decide whether to perform a database recovery
immediately after an instant recovery or not:
• To perform only an instant recovery, click Restore.
• To automatically perform a database recovery after an instant recovery,
select the recovery options. For details refer to “Database recovery
options” on page 223.
Click Restore.
Data Protector recovers the database after performing instant recovery by
switching the database to mount state, restoring the necessary archive redo
logs from tape, and applying the redo logs.
Database recovery options
User name (UNIX systems only) Specifies the user name under which the instant
recovery is performed. The user needs to be a
member of the DBA group.
User group (UNIX systems only) Specifies the user group the user in the User name
field belongs to.
NOTE:
The User name and the User group
must be the same as defined in the
backup ownership.
Recovery Enables database recovery after instant recovery.
Recover until The options in this drop-down list enables you to
specify to which point in time you would like the
recovery to be performed.
The following options are available:
Now: All existing archive logs are applied.
Selected time: Only archive logs until the specified
time are applied.
Selected logseq/ thread number: Specifies an
incomplete recovery. Only archive logs with a
Zero downtime backup integration guide 223
To Next Page
Need help?
General