HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 161
set led
Description Changes the state of the identification LED on a specified disk or enclosure. For a disk this affects the
Fault/UID LED. For an enclosure this affects the UID LED. LEDs are described in the User Guide.
Syntax To set a disk LED:
set led
disk ID
enable|disable|on|off
To set an enclosure LED:
set led
enclosure ID
enable|disable|on|off
Parameters disk ID
The disk to locate. For disk syntax, see Command syntax on page 22.
enclosure ID
The enclosure to locate.
enable|disable|on|off
Specifies to set or unset the LED.
Example Identify disk 5 in the first enclosure:
# set led disk 1.5 on
Success: Command completed successfully. - Enabling identification LED for disk
1.5... (2012-01-21 12:23:18)
Stop identifying the first enclosure:
# set led enclosure 1 off
Success: Disabling identification LED for enclosure 1... (2012-01-21 12:24:03)

HP P2000 G3 Specifications

General

Brand	HP
Model	P2000 G3
Category	Storage
Language	English