HP P2000 G3 Cli Reference Guide

36 Alphabetical list of commands
add replication-volume
Description Adds an existing secondary volume to a replication set. The volume can be on the same system as
the primary volume or on a remote system.
A secondary volume is a master volume created specifically for use as the destination for a
replication by using the create master-volume command's prepare-replication-volume
parameter.
Secondary volumes serve as the destination for replicated data from the primary volume. When a
replicate snapshot or replicate volume command is issued, data is replicated from the primary
volume to the associated secondary volume in the replication set.
This command must be run on the primary system.
Syntax
add replication-volume
link-type FC|iSCSI
[max-queue #]
[nowait]
primary-volume volume
[priority low|medium|high]
[remote-system system]
secondary-address ip=IPs|wwnn=WWNNs|wwpn=WWPNs
[set replication-set]
replication-volume
Parameters link-type FC|iSCSI
Specifies the type of ports being used for the inter-system link:
• FC: FC ports
• iSCSI: iSCSI ports
max-queue #
Optional. Number of replication images to consider when determining the next image to replicate:
1–64. Used only if the on-collision parameter is set to oldest.
nowait
Optional. Adding a volume to a replication set can take the Storage Controller several minutes to
complete. This parameter allows that processing to continue in the background so the Management
Controller can process other commands.
primary-volume volume
Name or serial number of the replication volume to be the primary volume for the replication set.
priority low|medium|high
Optional. Priority of the replication process on the replication volume: low, medium, or high.
remote-system system
Optional for a local volume; required for a remote volume if the secondary-address parameter
is not specified. Name or network-port IP address of the remote system.
secondary-address ip=IPs|wwnn=WWNNs|wwpn=WWPNs
Optional for a local volume; required for a remote volume if the remote-system parameter is not
specified. Specifies host ports on the remote system by IP address, World Wide Node Name, or
World Wide Port Name. An IP address value can include a port number; for example,
10.134.2.1:3260. Multiple values must be separated by commas and no spaces; for example:
ip=10.134.2.1,10.134.2.2.
set replication-set
Optional. Name or serial number of the replication set.
replication-volume
Name or serial number of the secondary volume to add. If the name is not unique across replication
sets, specify the set parameter.

HP P2000 G3 Specifications

General

Brand	HP
Model	P2000 G3
Category	Storage
Language	English