256 Alphabetical list of commands
show ntp-status
Description Shows the status of the use of Network Time Protocol (NTP) in the system.
Syntax
show ntp-status
Output NTP Status
• activated: NTP is enabled.
• deactivated: NTP is disabled.
NTP Server Address
NTP server IP address, or 0.0.0.0 if not set.
Last Server Contact
Date and time in the format year-month-day hour:minutes:seconds of the last message
received from the NTP server; or none.
Example Show NTP status for the system:
# show ntp-status
NTP Status
----------
NTP Status: activated
NTP Server Address: 69.10.36.3
Last Server Contact: 2012-01-18 15:30:44
Success: Command completed successfully. (2012-01-18 15:39:41)
Basetypes • ntp-status
• status
See also • set controller-date
To Next Page
Loading...
Need help?
General