HP P2000 G3 Cli Reference Guide

HP P2000 G3 MSA System CLI Reference Guide 211
show debug-log-parameters
Description For use by or with direction from a service technician.
Shows which debug message types are enabled (On) or disabled (Off) for inclusion in the Storage
Controller debug log.
Syntax
show debug-log-parameters
Output • host: Host interface debug messages. Enabled by default.
• disk: Disk interface debug messages. Enabled by default.
• mem: Internal memory debug messages. Disabled by default.
• fo: Failover and recovery debug messages. Enabled by default.
• msg: Inter-controller message debug messages. Enabled by default.
• ioa: I/O interface driver debug messages (standard). Enabled by default.
• iob: I/O interface driver debug messages (resource counts). Disabled by default.
• ioc: I/O interface driver debug messages (upper layer, verbose). Disabled by default.
• iod: I/O interface driver debug messages (lower layer, verbose). Disabled by default.
• misc: Internal debug messages. Enabled by default.
• rcm: Removable-component manager debug messages. Disabled by default.
• raid: RAID debug messages. Enabled by default.
• cache: Cache debug messages. Enabled by default.
• emp: Enclosure Management Processor debug messages. Enabled by default.
• capi: Internal Configuration API debug messages. Enabled by default.
• mui: Internal service interface debug messages. Enabled by default.
• bkcfg: Internal configuration debug messages. Enabled by default.
• awt: Auto-write-through cache triggers debug messages. Disabled by default.
• res2: Internal debug messages. Disabled by default.
• capi2: Internal Configuration API tracing debug messages. Disabled by default.
• dms: Snapshot feature debug messages. Enabled by default.
• fruid: FRU ID debug messages. Enabled by default.
• resmgr: Reservation Manager debug messages. Disabled by default.
• init: Not used.
• ps: Not used.
• hb: Not used.
Example Show debug log parameters:
# show debug-log-parameters
Debug Log Parameters
--------------------
host: On
disk: On
mem: Off
...
Success: Command completed successfully. (2012-01-18 14:59:52)
Basetypes • debug-log-parameters
• status
See also • set debug-log-parameters

HP P2000 G3 Specifications

General

Brand	HP
Model	P2000 G3
Category	Storage
Language	English