7.3.2 Configuring System Software for a router to Load for the Next
Startup
If you need to upgrade system software of a router, you can specify the router system software
to be loaded at the next startup.
Context
The system will continue to load the current system software at each startup until different system
software is specified for the next system startup. To change system software for the next startup,
you need to specify the system software you require.
The filename extension of the system software must be .cc and the file must be stored in the root
directory of a storage device.
Procedure
Step 1 Run:
startup system-software filename
The AR1200 system software to be loaded at the next startup of the router is configured.
----End
7.3.3 Configuring the Configuration File for Router to Load at the
Next Startup
Before restarting a router, you can specify which configuration files will be loaded at the next
startup.
Context
Run the display startup command on the router to check whether a specific configuration file
is set to be loaded at the next startup. If a specific configuration file is not specified, the default
configuration file will be loaded at the next startup.
The filename extension of the configuration file must be .cfg or .zip, and the file must be stored
in the root directory of a storage device.
When the router is powered on, it reads the configuration file from the flash memory by default
to initialize. The data in this configuration file is the initial configuration. If no configuration
file is saved in the flash memory, the router uses default parameters to initiate.
Procedure
l Run:
startup saved-configuration configuration-file
A configuration file is saved for the router to load at next startup.
----End
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration 7 Configuring System Startup
Issue 04 (2012-05-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
139
To Next Page
Loading...
Need help?
General
