Procedure
l Run the display sftp-client command to check the source IP address of the SFTP client on
the SSH client.
----End
Example
Run the display sftp-client command on the client to view the source parameters of the device
functioning as an SFTP client.
<Huawei> display sftp-client
Info: The source address of SFTP client is 1.1.1.1
8.7 Configuration Examples
This section describes examples for access another device. The examples explain networking
requirements, configuration notes, and configuration roadmap.
8.7.1 Example for Configuring Telnet Services
This example shows how to configure authentication modes and passwords for users to log in
using Telnet.
Networking Requirements
As shown in Figure 8-5, Router A and Router B can ping each other. A user logs in to Router
B from Router A using Telnet.
Figure 8-5 Networking diagram for configuring user login with Telnet services
RouterB
RouterA
Eth1/0/0
1.1.1.1/24
Eth1/0/0
1.1.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1. On Router B, configure authentication modes and passwords for VTY0 to VTY4.
2. Configure passwords for users to log in to Router B from Router A using Telnet.
3. Configure a Telnet server port number on Router B so that users log in through a single
specific port only.
Data Preparation
To complete the configuration, you need the following data:
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration 8 Accessing Another Device
Issue 04 (2012-05-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
169
To Next Page
Loading...
Need help?
General
